Aposonic A-S1602R20B Manuel d'utilisateur télécharger pdf (Page 47)

- 47 -

 Numeric (ENTER)

Press these buttons to select the alarm input.

 COPY (

)

Press this button to copy the settings of the focus alarm input to all the following

alarm inputs. (EX. focus alarm input is 5, its settings will be copied to those of

alarm inputs 6-8.)

 ESC (Mouse: Right Click)

Press this button to escape from this screen, and return to Setup Menu display. If

the Save dialog is shown, press ENTER to exit and save, ESC (Mouse: Right

Click) to exit without saving.

Following is a brief description for each item and its specific operations:

 Normal State – press +/- buttons to select N/A, Close or Open. Please check

the signal type, normally close or normally open, connected to the alarm input

terminal on the rear panel of the system. If there’s no signal connected, please

select N/A – Not Available, and the following items will not be settable. The

default setting is Open.

 Focus Camera – the camera corresponding to this alarm input.

 Duration – response duration to define at most how long (in seconds) the Alarm

Out relay and the Buzzer will keep being triggered after this alarm input is

triggered. However, the Alarm Out relay and the Buzzer will be reset

immediately once this alarm input returns to normal. Press +/- buttons to adjust

the value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).

 Goto Preset – to define the preset position to go to for the Focus Camera if this

alarm input is triggered and the Focus Camera is a PTZ camera. For more

details about preset locations, please refer to Chapter 7 PTZ Control.

 Pre-record – to define how long before this alarm input is triggered the Focus

Camera shall be intensively recorded at Pre-record IPS. Press +/- buttons to

adjust the value. Please note that the actual pre-record time may be shorter than

the value set if the total size of the pre-record pictures exceeds the pre-record

buffer size of the system.

 Post-record – to define how long after this alarm input is triggered the Focus

Camera shall be intensively recorded at Event Record IPS. Press +/- buttons to

adjust the value.

 Alarm Out – to define which Alarm Output will be triggered when this alarm

input is triggered. Press +/- buttons to select none (N/A) or one of the Alarm

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 119 120

Pas de commentaire

Aposonic A-S1602R20B Manuel d'utilisateur Page 47