Aposonic A-S1602R20B Manuel d'utilisateur télécharger pdf (Page 42)

- 42 -

 ESC (Mouse: Right Click)

Press this button to escape from this screen, and return to Camera Setup display.

If the Save dialog is shown, press ENTER to exit and save, ESC (Mouse:

Right Click) to exit without saving.

Following is a brief description for each item and its specific operations:

 Duration – response duration to define at most how long (in seconds) the Alarm

Out relay and the Buzzer will keep being triggered after video loss is detected for

this camera. However, the Alarm Out relay and the Buzzer will be reset

immediately once the camera returns to normal. Press +/- buttons to adjust the

value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).

 Camera to go – the camera to go to the preset position in next field after video

loss is detected for this camera. “Camera to go” camera must be a PTZ camera.

 Goto Preset – to define the preset position to go to for the “Camera to go”

Camera in last field if video loss is detected for this camera. For more details

about preset locations, please refer to Chapter 7 PTZ Control.

 Pre-record – to define how long before video loss is detected this camera shall be

intensively recorded at Pre-record IPS. Press +/- buttons to adjust the value

(0-10 seconds, discrete). Please note that the actual pre-record time may be

shorter than the value set if the total size of the pre-record pictures exceeds the

pre-record buffer size of the system.

 Alarm Out – to define which Alarm Output will be triggered when video loss of

this camera is detected. Press +/- buttons to select none (N/A) or one of the

Alarm Outputs (1-4).

 Buzzer – to activate the internal Buzzer or not when video loss of this camera is

detected. Press ENTER or +/- (Mouse: Left click to check/uncheck this item.

The default setting is “ˇ” - checked.

 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this

item. The default setting is “ˇ” - checked.

 Screen Message – to display the event message on the screen or not. Press

ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.

 E-mail – to send the event e-mail to remote station or not. The e-mail will be

sent to the predefined receivers at the moment when the event is triggered. Press

ENTER or +/- to check/uncheck this item. The default setting is “–” -

unchecked.

 FTP – to send the recorded event video/audio files to FTP server or not. Press

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 119 120

Pas de commentaire

Aposonic A-S1602R20B Manuel d'utilisateur Page 42