Aposonic A-S1602R20B Manuel d'utilisateur télécharger pdf (Page 44)

- 44 -

 Camera to go – the camera to go to the preset position in next field after motion

is detected for this camera. “Camera to go” camera must be a PTZ camera.

 Goto Preset – to define the preset position to go to for the “Camera to go”

Camera in last field if motion is detected for this camera. For more details about

preset locations, please refer to Chapter 7 PTZ Control.

 Pre-record – to define how long before motion is detected this camera shall be

intensively recorded at Pre-record IPS. Press +/- buttons to adjust the value

(0-10 seconds, discrete). Please note that the actual pre-record time may be

shorter than the value set if the total size of the pre-record pictures exceeds the

pre-record buffer size of the system.

 Post-record – to define how long after motion is detected this camera shall be

intensively recorded at Event Record IPS. Press +/- buttons to adjust the value

(0 second - 60 minutes, discrete).

 Alarm Out – to define which Alarm Output will be triggered when motion of this

camera is detected. Press +/- buttons to select none (N/A) or one of the Alarm

Outputs (1-4).

 Buzzer – to activate the internal Buzzer or not when motion of this camera is

detected. Press ENTER or +/- (Mouse: Left click) to check/uncheck this item.

The default setting is “ˇ” - checked.

 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this

item. The default setting is “ˇ” - checked.

 Screen Message – to display the event message on the screen or not. Press

ENTER or +/- to check/uncheck this item. The default setting is “ˇ” - checked.

 E-mail – to send the event e-mail to remote station or not. The e-mail will be

sent to the predefined receivers when the event is triggered. Press ENTER or

+/- to check/uncheck this item. The default setting is “–” - unchecked.

 FTP – to send the recorded event video/audio files to FTP server or not. Press

ENTER or +/- to check/uncheck this item. The default setting is “–” -

unchecked.

 Detection Settings.. – used to setup the motion detection settings, including

detection area and sensitivity, when motion is detected for this camera. Please

note that the detection area and sensitivity are also used for the Smart Search

information. There won’t be any Smart Search information stored outside

the detection area. So, it’s better to enable the whole area if the motion

detection for the camera is disabled (and only Smart Search is used). Press

ENTER in Settings.. to call up Motion Detection Setup (as shown) for this

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 119 120

Pas de commentaire

Aposonic A-S1602R20B Manuel d'utilisateur Page 44