Aposonic A-S1602R20B Manuel d'utilisateur télécharger pdf (Page 55)

- 55 -

Click) to exit without saving.

Following is a brief description for each item and its specific operations:

 Size (GB) – the total HDD storage in GB (Giga-Byte) for Alarm Record and

Normal Record respectively. This item is just for information. Please refer

to Section 6.6.1 for more detailed information and setup of each individual HDD.

Please note that if the total alarm record size is zero, the alarm video/audio

will be recorded in normal record partition. Please note that if the total

normal record size is zero, the normal video/audio will be recorded in alarm

record partition.

 Auto Overwrite – automatic overwrite of the recorded video/audio from HDD#1

when the Alarm/Normal Record disk drive capacity reaches the end of the last

HDD. If Auto Overwrite is disabled and the Alarm/Normal Record disk drive

capacity reaches the end, the system will not overwrite the recorded video/audio,

and hence not record Alarm/Normal video/audio, until the user presses the Alarm

Reset button. Press ENTER or +/- to check/uncheck this item. The default

setting is “ˇ” - checked.

 HDD Full Action – actions when Alarm/Normal Record disk drive capacity

reaches the end of the last HDD. Press ENTER or +/- to check/uncheck this

item. The default setting is “ˇ” - checked.

 Duration – response duration to define at most how long (in seconds) the Alarm

Out relay and the Buzzer will keep being triggered after the corresponding

partition, Alarm Record or Normal Record, is full. Press +/- buttons to adjust the

value (3 seconds - 60 minutes, discrete, ‘-‘ for ‘Forever’).

 Alarm Out – to define which Alarm Output will be triggered when the

corresponding partition, Alarm Record or Normal Record, is full. Press +/-

buttons to select none (N/A) or one of the Alarm Outputs.

 Buzzer – to activate the internal Buzzer or not when the corresponding partition,

Alarm Record or Normal Record, is full. Press ENTER or +/- to check/uncheck

this item. The default setting is “ˇ” - checked.

 Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this

item. The default setting is “ˇ” - checked.

 E-mail – to send the event e-mail to remote station or not. The e-mail will be

sent to the predefined receivers when the event is triggered. Press ENTER or

+/- to check/uncheck this item. The default setting is “–” - unchecked.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 119 120

Pas de commentaire

Aposonic A-S1602R20B Manuel d'utilisateur Page 55