Aposonic A-S0401R1 Manuel d'utilisateur

USER MANUAL 04 CHANNELS DIGITAL VIDEO RECORDER INSTRUCTION MANUAL To obtain the best performance and ensure device function c

10 COPY : Within the playback mode, press “ ENTER/ COPY ” button to start backup record and press “ ENTER/ COPY ” again to end backup. The user can se

11 Terminal Connectors: EXAMPLE 1：Connect Alarm In One with PIR (Passive Infrared). EXAMPLE 2：Connect with Alarm Siren at Relay N.O. D+

12 2.5 IR REMOTE CONTROL ITEM REC Press REC to start recording and press twice to stop. 1 - 4 Select channel 1-4 with full screen. QUAD Fast backwa

13 2.6 PTZ (PAN, TILT AND ZOOM) CAMERA Following diagram for DVR connect between PTZ camera & joystick controller, for DVR to control PTZ camera

14 3 SYSTEM SETUP 3.1 MENU SETUP INTERFACE(GUI) A. CAMERA SET B. RECORD SETUP C. ALARM SETUP D. NETWORK

15 E. AUTHORITY SETUP F. HDD MANAGEMENT G. SYSTEM SETUP H. SYSTEM SETUP

16 3.2 LIVE VIEWING AND POP-UP MENU NOTE：The pop-up menu can be activated by moving the mouse cruise to the bottom of the live viewing screen. A

17 NOTE： Only for the camera supported PTZ function. SPEED DOME CONTROL / / / Direction key ; Preset Point Minimize t

18 PTZ SETUP MENU PROTOCOL: Use drop down list to change the connection protocol. BAUD RATE: Use drop down list to change the BAUD rate. ID: Use

19 A. CAMERA SETUP A-1. DISPLAY Use the mouse to enable or disable the camera display. A-2. TITLE Press the mouse to change the nam

2 FCC Compliance USER-INSTALLER CAUTION: YOUR AUTHORITY TO OPERATE THIS FCC VERIFIED EQUIPMENT COULD BE VOIDED IF YOU MAKE CHANGES OR MODIFICATIONS

20 B-2. SENSITIVITY Press ◄ or ► to change sensitivity level. B-3. RELAY DWELL Press ◄ or ► to change the relay time or disable relay function. B-4.

21 : Cancel the above setting. D. SPEEDDOME SETUP PROTOCOL: Use drop down list to change the connection protocol. BAUD RATE: Use drop down list

22 3.4 RECORD SETUP A. AUDIO RECORD Use the mouse to enable or disable the audio record function. B. POST-ALARM RECORDING TIME Press ◄ or ► to ch

23 G. SCHEDULE SETUP Use the mouse to select the schedule setting which is including day, time and schedule mode of recording. Red is presented to

24 3.5 ALARM SETUP A. ALARM TRIGGER SETUP A-1. HDD TEMP. WARNING Enable or disable the hard disk over-heated warning function. A-2. HDD TEM

25 B. ALARM OUTPUT SETUP Press ◄ or ► to setup buzzer and relay time. B-1. BUZZER TIME Use ◄ or ► to setup the external alarm buzzer time. The value

26 3.6 NETWORK SETUP A. IP ADDRESS SETUP Press ◄ or ► to DVR IP address. A-1. IP MODE Press drop down list to change IP mode to STATIC IP or DHCP.

27 B. PPPoE SETUP B-1. PPPoE Setting Press the drop down list to enable or disable PPPoE. B-2. User Name Insert the user name (ADSL account) which pr

28 D. DDNS SETUP D-1. DDNS Enable Click the checkbox to enable or disable DDNS function. D-2. Provider Click the drop down list to select DDNS provid

29 E-3. SMTP Port The port of SMTP (known as Simple Mail Transfer Protocol). (Default value is 25) E-4. User Name The user name while log in to the ma

3TABLE OF CONTENTS 1 INTRODUCTION...

30 3.7 AUTHORITY Press ▲ or ▼ to select items. Press ◄ or ► to change values. Press SET to see more options. A. HDD Format Check User Pa

31 E-2. Add User After click button, the setup page will present in the following. The user can distribute the authority and the permission for th

32 3.8 HDD MANAGEMENT A. OVERWRITE MODE Click the drop down list to enable or disable overwrite function. B. HARD DISK FULL WARNING Click the dro

33 3.9 SYSTEM SETUP A. Software Update Click button to perform firmware updating. Click to start software update. B. Configure Setup Click

34 C. Time Setup Click button within “Time” block can adjust and synchronize the time of the dvr as the system time of the PC. Moreover, if the us

35 E. Status Display Setup Use the mouse to click the display setup items, which is including “Date and Time Display”, “Record Information Display”,

36 4 DVR PLAYBACK Click the playback button on the pop-up menu. Note: the pop-up menu can be activated by moving the mouse cruise to the

37 4.1 TIME SEARCH Select the time which is going to playback (including the date and the time) and then click button to start playback. If the t

38 4.3 BACKUP After click “BACKUP” button, use the drop down list to select “Media Device” which has USB and DVD-RW (in 08CH and 16CH models) two o

39 4.4 SYSTEM LOG System log reserves all the logs. The maximum number of reserved log is 2000. Moreover, click “Log Filter” button can select whi

4Half D1- 720x240...67 CIF

40 5 BACKUP PLAYBACK SYSTEM REQUIREMENT CPU: Intel Celeron 1.6G MEMORY: 256MB. VGA: 32MB VGA RESOLUTION: 1024 x 768. OS: Windows XP / 2000 SUGGESTE

41 B. HDD PLAY Play about all the data from the Hard disk of DVR or perform the specific Time and Event Search to play. Note: Remove the DVR HDD and

42 B-1. TIME SEARCH Insert search Date and Time and then click to play all the searched film. B-2. EVENT SEARCH It will display all the events

43 Then, select the “StartTime” and “EndTime”. After that, press button to choose the storage destination and press to start reserving. Finall

44 5.2 USB & LOCAL BACKUP FILE PLAYBACK A. Plug the USB disk into PC or check the local backup folder. If using USB mode, please double click

45 C. Open the USB disk located driver letter. (Example E:) or the local backup folder, and pick the file to playback. The backup file will named as

46 5.3 BACKUP FILE TO AVI A. Please select specific channel to backup. B. During video playback mode please press AVI bottom to start. C.

47 6 NETWORK VIEWING & PLAYBACK SYSTEM REQUIREMENT CPU: Intel Celeron 1.6G MEMORY: 256MB. VGA: 32MB VGA RESOLUTION: 1024 x 768. OS: Windows XP /

48 NOTE: Please input correct network parameters without blank spaces. On Device Lists, it lists all servers. Click on one server and then its IP se

49 1 2 3 4 5 Above three options are all based on select as the prompt. As indicated in the dialogue box. Please select "YES."

5 1 INTRODUCTION 1.1 FEATURE z H.264 hardware video compression z Recording rate up to 60 PPS @ D1 z Support CMS (Central Management System) z

50 OPTION 2: ADD TO TRUSTED SITES IE Æ Tools Æ Internet Options Æ Security Æ Trusted sites Æ Sites

51 6.3 LOGIN A. INSTALL ACTIVEX B. START INSTALL ACTIVEX C. ACCOUNT & PASSWORD LOGIN After IP setup and connect to network or

52 6.4 REMOTE CONTROL LIVE VIEWING A. DVR Configuration Get into DVR network menu. B. PTZ Control PTZ control f

53 C. SYSTEM TIME Live viewing mode: The current live viewing time. D. SCREEN FORMAT Switch screen format and click twice to sw

54 PLAYBACK by TIME SEARCH & EVENT SEARCH A. HDD Select User can select HDD1 or HDD2 for playback B. Playback Time

55 Click to operate Time-Point backup. TIME-POINT BACKUP First, select Start and End backup time which have to among the Record Time. Then, c

56 OTHER FUNCTIONS User can use other functions by clicking the left of mouse A. Snapshot: User can save any single pict

57 6.5 CONFIGURE A. System - System Information A-1 SYSTEM INFORMATION SERVER NAME: This name will show on the IP Installer. A-2 NTP Setting NTP S

58 B-1. ANONYMOUS USER LOGIN: YES: Accept anonymous user login without password as guest login. NO: Anonymous login unacceptable. B-2. USER MANAGEMENT

59 D. NETWORK – IP SETTING D-1. IP ASSIGNMENT DHCP: In Dynamic Host Configuration Protocol (DHCP) mode, DHCP server will get setting done automat

6 RECORDING RESOLUTION ( Half D1) 720 x 240 (NTSC) / 720 x 288 (PAL) RECORDING RESOLUTION (CIF) 360 x 240 (NTSC) / 360 x 288 (PAL) RECORDING RATE ( D

60 E-1. PPPoE SETTING Click on Enabled to enable ADSL dial function. Username: Username for ADSL account. Password: Password for ADSL account. After

61 F-1. DYNDNS.ORG DDNS SETTING - DYNDNS.ORG PROVIDER: Select dyndns.org HOSTNAME: The registered hostname in DYNDNS.ORG. USERNAME: The registered us

62 DDNS SETTING – DDNS.CAMDDNS.COM PROVIDER: Select ddns.camddns.com USERNAME: The registered username in DDNS.CAMDDNS.COM. SCHEDULE UPDATE: A period

63 Finally, the DVR domain name○5 (http://DVR_GODDNS.ddns.camddns.com) will be shown on the state block. NOTE: 1. If the user selects another prov

64 Mail Server: The IP address of Mail Server (i.e. mail.huntelec.com.tw). SMTP Port: The port of SMTP (known as Simple Mail Transfer Protocol). (Defa

65 APPENDIX A: RECORDING TIME LAPSE (HOURS) FULL D1-720 x 480 500 GB HDD

66 120 970 683 471 401 309 60 1941 1367 942 802 618 30 3883 2734 1885 1604 1236 15 7767 5469 3770 3209 2473

67 Half D1- 720x240 500 GB HDD UNIT: HOURSRECORDING SPEED （IPS）

68 60 3236 1941 1348 961 758 30 6472 3883 2696 1922 1517 15 12945 7767 5393 3845 3034

69 CIF-360x240 500 GB HDD UNIT: HOURSRECORDING SPEED （IPS） LOW

7 DDNS Yes E-MAIL & FTP Yes NETWORK IP Static/ Dynamic/ PPPoE MULTI-REMOTE CLIENT Yes ( 4 Clients at the same time available) PDA/ CELL PHONE SUPP

70 60 6068 3734 2023 1214 981 30 12136 7468 4045 2427 1961 15 24273 14937 8091 4855 3923 * The value is for reference onl

71 APPENDIX B: HDD COMPATIBLE TABLE Brand Model Capacity others SEAGATE STM3250820AS 250 GB 7200 10 ST3250310SV

72 APPENDIX C: ERROR MESSAGE LIST ERROR MESSAGE ERROR STATUS & REASON NOTEDISK ACCESS ERROR! H.D.D. Data structure Un-normal. Data does not rec

8 2 HARDWARE OVERVIEW 2.1 FRONT PANEL DVR OPERATION NO. LABEL OPERATION PTZ 1 IR Sensor For Remote Control. 2 LED REC Led Indicator 3 CO

9 2.2 BACK PANEL NO. LABEL OPERATION 1 VIDEO INPUT Video input with BNC connector. 2 AUDIO OUT Audio output 3 AUDIO IN Audio input. 4 SPOT SPOT conn